|
Glow
in the Dark, Photo Luminescent Sticker Film and Board are PVC
sheets with Glow Pigment applied on them. Glow Sticker Film and
Board are two different products. Glow Film is made from soft
PVC and is flexible and can be cut easily into any required shape,
either with a pair of scissors or by die cutting. Glow Board is
made from hard PVC and is a rigid non flexible material.
These
luminous products come with or without a layer of transparent
PET protective sheet. The purpose of this PET sheet is to provide
additional protection to the glow surface. The PET layer must
be removed if you intend to do any sort of printing on this material.
Silk Screen Printing and Laser Printing are the only direct printing
methods suitable for this product.
You
can also choose between adhesive and non adhesive backing. Adhesive
backing enables the film or board to be stuck on any normal, flat
surface, free from oil or grease. While this product can be used
outdoors (product code PLFGH-100. See below for details), the
adhesive is not strong enough for outdoor use.
This
product is a finished product and can be used to create glow signs or
designs (by indirect printing), labels, or route markers in emergency
situations. Refer to this page for more
ideas on glow stickers.
This
product comes in the following grades.
Super
High Glow (over 16 hours),
High Glow (up to 12 hours),
Mid Glow (up to 8 hours) and
Low Glow (up to 2 hours).
The
Table below shows photos of the various grades.
 |
Photo
taken in normal light |
After 1 minute
|
After 30 minutes
|
|
|
